Operating methods of power busbar processing equipment

Power on the machine and turn on the electrical box switch. Press the "Oil Pump Start" button to start the motor. (When connecting the power for the first time, pay attention to the motor rotation direction. If the direction is incorrect, swap two phases of the three-phase power supply; the motor will rotate in the opposite direction.)

Unit (Punching) To operate the punching unit, press the "Punching Operation" button on the main control panel. The "Punching Operation" indicator light on the main panel will illuminate. Press the foot switch or the corresponding manual switch button on the punching unit. The punch will descend until it hits the bottom dead center switch, at which point it will return to the top dead center. If the foot switch or the corresponding manual button is released during the downward movement of the punch, the punch will stop. If the foot switch or the corresponding manual button is pressed again, the punch will continue to descend; if the "Up" button on the punching unit panel is pressed, the punch will return to the top dead center and stop.

Unit (Shearing) To operate the shearing unit, turn the "Shearing Operation" switch on the main control panel to the "Start" position. The "Shearing Operation" indicator light on the main panel will illuminate. Pressing the foot switch or the corresponding manual button on the shear unit will cause the slider to descend until it hits the bottom dead center switch, then return to the top dead center. If the foot switch or manual button is released during the descent, the slider will stop. If the foot switch is pressed again or the manual button is pressed, the slider will continue to descend; if the "Up" button on the shear unit panel is pressed, the slider will return to the top dead center and stop.

**Unit (Bending)** To start the bending unit, press the "Bending Operation" switch on the main control panel. The "Bending Operation" indicator light on the main panel will illuminate. Pressing the foot switch or the corresponding manual button on the bending unit will cause the slider to move forward until it hits the front dead center switch or the "Return" button is pressed, then the slider will return to the rear dead center. If the foot switch or manual button is pressed during the forward movement, the slider will stop. If the foot switch is pressed again or the manual button is pressed, the slider will continue to move forward; if the "Return" button on the bending unit panel is pressed, the slider will return to the top dead center and stop. Vertical Bending: The operator replaces the vertical bending die, inserts the two stop pins into the two symmetrical holes on the table, places the nut into the opening in the middle of the die, and presses the foot switch. Note that it should be jogged first until the desired angle is achieved. If producing a batch of this product, the inspection plate can be adjusted to the position reached in the first stroke. Embossing: This function can be achieved by replacing the embossing die. Reverse Flattening: If the angle is too large due to improper operation, the reverse flattening die can be used to flatten in the opposite direction. "Emergency Stop": In case of an emergency, please press the emergency stop button.